Beschreibung
Max Trax Quick Release Upgrade
Quick-release pins that replace the screw-in tops on your existing magnetic supports. Half the access time to your recovery boards.
Use it for: Swap the screw-in tops on your existing MaxTrax magnetic supports for quick-release pins and halve the access time to your boards.
What it fits: Upgrade kit for Tactic MaxTrax magnetic supports you already own. 2 or 4 pins, each with its plastic part and bolt. Magnets not included. Source your own M8 screws for rack mounting.
Shipping: Ships within 48 h. Free shipping from CHF150, £150, €250 or $299.
What you get
2 or 4 quick-release pins
Each pin comes with the plastic part that goes into the Max Trax support hole, and the bolt it needs. Choose the count at checkout.
Buy two, not four
Keep the previous version on the other two mounts if that feels safer against theft. Access time to your boards still drops by half.
Any rack you choose
You can install this on any rack. Source your own M8 screws — we cannot know how thick your panel is.
Magnets not included
This is an upgrade kit for supports you already own. It does not include the magnets.
Swapping it onto your existing supports
The chrome cylinder on your current supports is tightened with Loctite, so it can be hard to unscrew. Take your time and do this properly, so you do not hurt yourself or damage the parts.
- 1. Remove the magnetic supports from the Max Trax recovery boards.
- 2. With the magnets, chrome cylinder and black spacer in hand — plastic top screw not installed — put some tape, duct tape works, on the upper part of the cylinders.
- 3. Hold the magnet with one hand. With the other, apply pressure on the taped section with a clamp and unscrew it.
Do not use the plastic spacer to untighten the chrome cylinder. You will damage it.
From the wild
View this post on Instagram
Sam (@big.adventure.van) on Instagram
Max Trax is a trademark of its owner. Tactic Engineering is an independent manufacturer and is not affiliated with, endorsed by, or sponsored by MaxTrax.
Quick questions
Should I buy two pins or four?
Two is fine: keep the previous version on the other two mounts if that feels safer against theft. Access time still drops by half.
Pairs well with
- Magnetic Quick Release Supports for MaxTrax MK2/LITE
- Max Trax MK2 / XTREME: pins only, no magnets.
